[TriLUG] HP Printer

[Patrick Williams]

The HP4300 network printer drops to the default setting after each job is
completed.  We often want to change that default without traveling to the
printer, or just keep the last setting given by the currently finished job.
Does anyone know of a way to make it retain the last settings?

I have used telnet to disable the Logical Channel Break on the Jet Direct
but that is overkill and shuts down things that I want... like flushing out
the last page of the currently finished job.

Regards,

Patrick Williams


----- Original Message -----
From: "Jeff Jackowski" <jeffj1 at hiwaay.net>
To: <trilug at trilug.org>
Sent: Sunday, June 01, 2003 11:10 PM
Subject: Re: [TriLUG] NVidia question


> On 1 Jun 2003, Roy Vestal wrote:
>
> >I have an Jaton NVidia GeForce2 MX-200 32MB card installed on an RHL 9.
> >It's a 4x AGP card running in a 2x slot. When I run the NVidia driver, X
> >sometimes gives a "hardware freeze". I put that in quotes, since the
> >mouse still responds but no keyboard including the NumLock. I have to
> >power off or reset in order to restart. Without the driver X works fine.
> >I'm running Gnome on this box.
>
> Have you tried Ctrl-Del-Backspace? I think that is the key combination
> that is supposed to kill X. I have on one occasion had to kill X remotely
> because that combination did not work. The result was that the text
> consoles never displayed until after rebooting, but they still responded
> and I could still get X running again.
>
> Hopefully you'll get more help soon since none of what I wrote solves the
> problem.
>
> --
> Jeff Jackowski
>         http://ro.com/~jeffj/
>
> _______________________________________________
> TriLUG mailing list
>     http://www.trilug.org/mailman/listinfo/trilug
> TriLUG Organizational FAQ:
>     http://www.trilug.org/faq/TriLUG-faq.html
>