[TriLUG] setting full duplex (part 2)

[spain at ncssm.edu]

module is the 3c59x card.. 
 
./ethtool -s autoneg off speed 100 duplex full
 
doesn't work .. it gives me " Cannot get current device settings: Device not
supported"
 
although I do see a setting for full duplex then I ./modinfo 3c59x..
 
Does this mean I need an updated driver that will allow me to set additional
settings.. 
 
Thanks for all the good suggestions.. they were all very effective.. 
 
 
 
 
  _____  

Sincerely,
Jamil Hassan Spain
NC School of Science and Mathematics | External Programs 
Phone: 919-416-2641
Web: www.dlt.ncssm.edu <http://www.dlt.ncssm.edu/> 
Email: spain at ncssm.edu <mailto:spain at ncssm.edu> 
  _____