[TriLUG] RH9 tape device?

[Scott Chilcote]

Hi Wayne,

 From my RH9 system's "dmesg" output:

> SCSI subsystem driver Revision: 1.00
> DC390: 0 adapters found
> DC395x (TRM-S1040) SCSI driver 1.41, 2002-06-21
> DC395x: Used settings: AdapterID=07, Speed=0(20.0MHz), DevMode=0x57
> DC395x:      AdaptMode=0x0f, Tags=4(16), DelayReset=1s
> DC395 : Connectors: ext50  Termination: Auto Low High
> DC395: Performing initial SCSI bus reset
> DC395x (TRM-S1040): 1 adapters found
> scsi0 : Tekram DC395U/UW/F DC315/U V1.41, 2002-06-21
>   Vendor: DEC       Model: TZ88     (C) DEC  Rev: CC34
>   Type:   Sequential-Access                  ANSI SCSI revision: 02
>   Vendor: TEAC      Model: CD-ROM CD-532S    Rev: 1.0A
>   Type:   CD-ROM                             ANSI SCSI revision: 02
> st: Version 20030406, bufsize 32768, max init. bufs 4, s/g segs 16
> Attached scsi tape st0 at scsi0, channel 0, id 5, lun 0

On the last line, it shows that my DLT4 tape drive is st0.

Good luck,

     Scott C.


Byarlay, Wayne A. wrote:

> doggone if I can determine what RH9 has called my Quantum DLT7000 SCSI
> tape drive...
> 
> Just know it's not /dev/nst0. (mt -f /dev/nst0 rewind does nothing).
> 
> Any ideas? 
>