[TriLUG] slackware ... grub?
Jason Faulkner
jason at oldos.org
Wed May 24 20:54:47 EDT 2006
Your new bootloader info probably isn't being written properly to the MBR.
Make sure to run grub-install /dev/foo (where foo=hd dev node)
--Jay
On 5/24/06, stan briggs <stan at stanbriggs.com> wrote:
> all,
>
> so i've been through the complete slackware 10.2 install three times now
> trying to figure out what i'm doing wrong. i thought that i was
> installing LILO incorrectly but even when i tried the installation
> without LILO i get the same symptom, which is:
>
> starts boot with bios-level hardware detection, pauses at the "boot from
> cd" prompt, and then proceeds to the word "GRUB" on a line by itself at
> which point it's a hard freeze.
>
> this machine had rh9 on it before with a small grub(?) partition which i
> removed (during my second installation) and added to the partition from
> which "/" is mounted.
>
> google/linux gave no joy.
>
> any ideas or suggestions?
>
> thanks,
> stan
>
>
> --
> TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
> TriLUG Organizational FAQ : http://trilug.org/faq/
> TriLUG Member Services FAQ : http://members.trilug.org/services_faq/
>
--
Jason Faulkner
http://oldos.org
More information about the TriLUG
mailing list