[TriLUG] LVM Experts

[Steve Kuekes]

Well, I got it working, I think.

I had to rename the volume group by UUID since I had 2 that were the 
same name.  Then after I rebooted, I could mount logical volumes inside 
the new renamed volume group.  (I probably didn't have to reboot, but I 
couldn't figure out what to do to get lvm refreshed).

Thanks for the advice.

Steve

Brian McCullough wrote:
> On Thu, Mar 12, 2009 at 02:10:11PM -0400, Alan Porter wrote:
>> Rename the volume group on the known drive. A LiveCD may help here.
> 
> You're right Alan.  I was reading that all ( both ) of the drives were
> already present, so the boot process would try to activate all of the
> drives, leaving him with the current confused state.
> 
> 
> Brian
> 
> 
> --
> TriLUG mailing list        : http://www.trilug.org/mailman/listinfo/trilug
> TriLUG FAQ  : http://www.trilug.org/wiki/Frequently_Asked_Questions

-- 
Steve Kuekes

Insight Racing - Urban Grand Challenge('07) - http://www.insightracing.org
Private Pilot: N9259R '95 Saratoga based at Sanford-Lee County Regional 
(TTA)
email: skuekes at nc.rr.com