[TriLUG] NFS on Fedora 13: how to register NFS with RPC?

Tim Jowers timjowers at gmail.com
Sat Dec 18 09:05:59 EST 2010


Anyone set up NFS on Fedora 13? I get:

[tim at monsterfc ~]$ showmount -e 192.168.2.101
clnt_create: RPC: Program not registered

The above is on the computer where I am setting up NFS server. I get
this message also when I run showmount on a Ubuntu system on the same
LAN; so, I'm guess I don't have NFS configured properly.

Any ideas?

Thanks,
TimJowers

Ref:
[tim at monsterfc ~]$ showmount -e 192.168.2.101
clnt_create: RPC: Program not registered
[tim at monsterfc ~]$ ifconfig
eth1      Link encap:Ethernet  HWaddr 00:16:76:7F:AA:44
          inet addr:192.168.2.101  Bcast:192.168.2.255  Mask:255.255.255.0
          inet6 addr: fe80::216:76ff:fe7f:aa44/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1141712 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1002594 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:850364455 (810.9 MiB)  TX bytes:183270319 (174.7 MiB)
          Interrupt:21 Base address:0x6000

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:31802 errors:0 dropped:0 overruns:0 frame:0
          TX packets:31802 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:2418353 (2.3 MiB)  TX bytes:2418353 (2.3 MiB)

[tim at monsterfc ~]$ service nfs status
rpc.svcgssd is stopped
rpc.mountd (pid 1475) is running...
nfsd (pid 1472 1471 1470 1469 1468 1467 1466 1465) is running...
rpc.rquotad (pid 1460) is running...

[tim at monsterfc ~]$ sestatus
SELinux status:                 disabled

[tim at monsterfc ~]$ service iptables status
/etc/init.d/iptables: line 53: /etc/sysconfig/iptables-config: Permission denied

[tim at monsterfc ~]$ su
Password:
[root at monsterfc tim]# service iptables status
Table: filter
Chain INPUT (policy ACCEPT)
num  target     prot opt source               destination

Chain FORWARD (policy ACCEPT)
num  target     prot opt source               destination

Chain OUTPUT (policy ACCEPT)
num  target     prot opt source               destination

[tim at monsterfc ~]$ cat /etc/exports
/home 192.168.0.0/32(ro,root_squash,insecure)
/home/tim	192.168.100.0/32(rw,sync,no_root_squash)
/home/NFS-share            */26(rw,sync)

[tim at monsterfc ~]$ cat /etc/hosts.deny
#
# hosts.deny	This file contains access rules which are used to
#		deny connections to network services that either use
#		the tcp_wrappers library or that have been
#		started through a tcp_wrappers-enabled xinetd.
#
#		The rules in this file can also be set up in
#		/etc/hosts.allow with a 'deny' option instead.
#
#		See 'man 5 hosts_options' and 'man 5 hosts_access'
#		for information on rule syntax.
#		See 'man tcpd' for information on tcp_wrappers
#
[tim at monsterfc ~]$ cat /etc/hosts.allow
#
# hosts.allow	This file contains access rules which are used to
#		allow or deny connections to network services that
#		either use the tcp_wrappers library or that have been
#		started through a tcp_wrappers-enabled xinetd.
#
#		See 'man 5 hosts_options' and 'man 5 hosts_access'
#		for information on rule syntax.
#		See 'man tcpd' for information on tcp_wrappers
#



More information about the TriLUG mailing list