[TriLUG] NFS on Fedora 13: how to register NFS with RPC?

[Matt Pusateri]

Is portmap running as well?


Matt P.

On Dec 18, 2010, at 9:05 AM, Tim Jowers wrote:

> Anyone set up NFS on Fedora 13? I get:
> 
> [tim at monsterfc ~]$ showmount -e 192.168.2.101
> clnt_create: RPC: Program not registered
> 
> The above is on the computer where I am setting up NFS server. I get
> this message also when I run showmount on a Ubuntu system on the same
> LAN; so, I'm guess I don't have NFS configured properly.
> 
> Any ideas?
> 
> Thanks,
> TimJowers
> 
> Ref:
> [tim at monsterfc ~]$ showmount -e 192.168.2.101
> clnt_create: RPC: Program not registered
> [tim at monsterfc ~]$ ifconfig
> eth1      Link encap:Ethernet  HWaddr 00:16:76:7F:AA:44
>          inet addr:192.168.2.101  Bcast:192.168.2.255  Mask:255.255.255.0
>          inet6 addr: fe80::216:76ff:fe7f:aa44/64 Scope:Link
>          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:1141712 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:1002594 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:850364455 (810.9 MiB)  TX bytes:183270319 (174.7 MiB)
>          Interrupt:21 Base address:0x6000
> 
> lo        Link encap:Local Loopback
>          inet addr:127.0.0.1  Mask:255.0.0.0
>          inet6 addr: ::1/128 Scope:Host
>          UP LOOPBACK RUNNING  MTU:16436  Metric:1
>          RX packets:31802 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:31802 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:0
>          RX bytes:2418353 (2.3 MiB)  TX bytes:2418353 (2.3 MiB)
> 
> [tim at monsterfc ~]$ service nfs status
> rpc.svcgssd is stopped
> rpc.mountd (pid 1475) is running...
> nfsd (pid 1472 1471 1470 1469 1468 1467 1466 1465) is running...
> rpc.rquotad (pid 1460) is running...
> 
> [tim at monsterfc ~]$ sestatus
> SELinux status:                 disabled
> 
> [tim at monsterfc ~]$ service iptables status
> /etc/init.d/iptables: line 53: /etc/sysconfig/iptables-config: Permission denied
> 
> [tim at monsterfc ~]$ su
> Password:
> [root at monsterfc tim]# service iptables status
> Table: filter
> Chain INPUT (policy ACCEPT)
> num  target     prot opt source               destination
> 
> Chain FORWARD (policy ACCEPT)
> num  target     prot opt source               destination
> 
> Chain OUTPUT (policy ACCEPT)
> num  target     prot opt source               destination
> 
> [tim at monsterfc ~]$ cat /etc/exports
> /home 192.168.0.0/32(ro,root_squash,insecure)
> /home/tim	192.168.100.0/32(rw,sync,no_root_squash)
> /home/NFS-share            */26(rw,sync)
> 
> [tim at monsterfc ~]$ cat /etc/hosts.deny
> #
> # hosts.deny	This file contains access rules which are used to
> #		deny connections to network services that either use
> #		the tcp_wrappers library or that have been
> #		started through a tcp_wrappers-enabled xinetd.
> #
> #		The rules in this file can also be set up in
> #		/etc/hosts.allow with a 'deny' option instead.
> #
> #		See 'man 5 hosts_options' and 'man 5 hosts_access'
> #		for information on rule syntax.
> #		See 'man tcpd' for information on tcp_wrappers
> #
> [tim at monsterfc ~]$ cat /etc/hosts.allow
> #
> # hosts.allow	This file contains access rules which are used to
> #		allow or deny connections to network services that
> #		either use the tcp_wrappers library or that have been
> #		started through a tcp_wrappers-enabled xinetd.
> #
> #		See 'man 5 hosts_options' and 'man 5 hosts_access'
> #		for information on rule syntax.
> #		See 'man tcpd' for information on tcp_wrappers
> #
> -- 
> This message was sent to: M. Pusateri <mpusateri at wickedtrails.com>
> To unsubscribe, send a blank message to trilug-leave at trilug.org from that address.
> TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
> Unsubscribe or edit options on the web	: http://www.trilug.org/mailman/options/trilug/mpusateri%40wickedtrails.com
> TriLUG FAQ          : http://www.trilug.org/wiki/Frequently_Asked_Questions