[TriLUG] OT: Local Supplier for Small Metric Tap?

[Brian Henning via TriLUG]

I stand corrected!  Useful knowledge!

-----Original Message-----
From: TriLUG [mailto:trilug-bounces at trilug.org] On Behalf Of Pete Soper via TriLUG
Sent: Thursday, April 07, 2016 11:42 AM
To: trilug at trilug.org
Subject: Re: [TriLUG] OT: Local Supplier for Small Metric Tap?

Burke Brothers hardware near the fair grounds in Raleigh has the .5 and also the .3 M3 tap on their shelves.
-Pete


On 04/07/2016 11:35 AM, Scott Chilcote via TriLUG wrote:
> Hi LUGgers,
>
> A project I'm building requires some components to be installed on a
> heat sink.  Due to the narrow fin spacing, I can't drill through-holes
> and use nuts and bolts.  The remaining option is to find a small enough
> tap and thread the holes.
>
> Does anyone know if there's a local store that is likely to have a 3
> millimeter tap?  The size M3-.50 appears to work best.
>
> Thanks,
>
>     Scott C.
>

-- 
This message was sent to: Brian <bhenning at pineinst.com>
To unsubscribe, send a blank message to trilug-leave at trilug.org from that address.
TriLUG mailing list : http://www.trilug.org/mailman/listinfo/trilug
Unsubscribe or edit options on the web	: http://www.trilug.org/mailman/options/trilug/bhenning%40pineinst.com
Welcome to TriLUG: http://trilug.org/welcome