[TriLUG] setting eth0 to full duplex

Magnus Hedemark chrish at trilug.org
Thu Jan 29 11:17:18 EST 2004


On Thu, 29 Jan 2004 spain at ncssm.edu wrote:

> How do I set the interface to full duplex or 100baseT and what syntax can I
> use.. if my ip was 192.168.1.100/24

It depends on what kind of card you have.  This is set in 
/etc/modules.conf and the syntax is completely dependent on what module is 
being assigned to your interface.




More information about the TriLUG mailing list