[TriLUG] Re: more than one USB device
Lance A. Brown
lance at bearcircle.net
Thu Feb 5 15:21:51 EST 2004
Check for the 2nd device showing up on the next sdX device. If your
first device is sdd, look for sde after plugging in the 2nd device.
--[Lance]
Daniel Monjar wrote:
> I have a USB camera and now a USB 'DiskOnKey' device. When I plug the
> first one in everything works as expected. But when I plug the 2nd in I
> get 'disk not recognized errors':
>
> Feb 3 10:15:33 dam kernel: hub.c: new USB device 00:1f.2-1, assigned
> address 3
> Feb 3 10:15:33 dam kernel: scsi5 : SCSI emulation for USB Mass Storage
> devices
> Feb 3 10:15:33 dam kernel: Vendor: M-Sys Model: DiskOnKey Rev: 4.70
> Feb 3 10:15:33 dam kernel: Type: Direct-Access ANSI SCSI revision: 02
> Feb 3 10:15:33 dam kernel: Attached scsi removable disk sdd at scsi5,
> channel 0, id 0, lun 0
> Feb 3 10:15:33 dam /etc/hotplug/scsi.agent: sd_mod allready loaded
> Feb 3 10:15:33 dam kernel: usb-uhci.c: interrupt, status 3, frame# 302
> Feb 3 10:15:33 dam kernel: sdd : READ CAPACITY failed.
> Feb 3 10:15:33 dam kernel: sdd : status = 1, message = 00, host = 0,
> driver = 08
> Feb 3 10:15:33 dam kernel: Current sd00:00: sense key Unit Attention
> Feb 3 10:15:33 dam kernel: Additional sense indicates Medium not present
>
> But if I reboot the problem goes away. How can I make the system forget
> about the first device without rebooting?
>
--
Carolina Spirit Quest: http://www.carolinaspiritquest.org/
Celebrate The Circle: http://www.angelfire.com/nc/celebratethecircle/
My LiveJournal: http://www.livejournal.com/users/labrown/
More information about the TriLUG
mailing list