[TriLUG] RHEL4 Network Install / DHCP Problem
shawnlhood at gmail.com
Thu Aug 10 15:39:23 EDT 2006
I'm having trouble with a Blade. It PXE boots fine into a network
install. The install runs great with the onboard Broadcom NICs. If I
install an expansion card that adds two interfaces, the problems
start. After anaconda starts, the machine issues a DHCP request.
This request isn't being seen by the DHCP server. It just will not
perform this network install with the expansion card in! Any ideas?
I'm passing ksdevice=eth0 during startup.
(910) 670-1819 Mobile
More information about the TriLUG