[TriLUG] RHEL4 Network Install / DHCP Problem

[Mark Fowle]

I had the same problem - We took the second card out and reinstalled
in after the install - It's a pain, but it works.


On 8/10/06, Shawn Hood <shawnlhood at gmail.com> wrote:
> List,
>
> I'm having trouble with a Blade.  It PXE boots fine into a network
> install.  The install runs great with the onboard Broadcom NICs.  If I
> install an expansion card that adds two interfaces, the problems
> start.  After anaconda starts, the machine issues a DHCP request.
> This request isn't being seen by the DHCP server.  It just will not
> perform this network install with the expansion card in!  Any ideas?
>
> I'm passing ksdevice=eth0 during startup.
>
>
> --
> Shawn Hood
> (910) 670-1819 Mobile
> --
> TriLUG mailing list        : http://www.trilug.org/mailman/listinfo/trilug
> TriLUG Organizational FAQ  : http://trilug.org/faq/
> TriLUG Member Services FAQ : http://members.trilug.org/services_faq/
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
>